How to Draft a One-Seam Skirt in 30 Minutes
comments (13) December 31st, 2008When you get within 1/2 inch of the dart, shorten your stitch length slightly and continue stitching directly off the edge of the fold at the tip of the dart.
![]() |
Lift the presser foot and pull out some thread, leaving 3- to 4-inch tails. |
Tie a loose square knot at the end of the dart to secure the thread.
![]() |
Do not pull the knot too tightly or the fabric will pucker. |
After you make this project, show off your work to other members!
Post your project in the gallery



















Comments (13)
Posted: 1:25 pm on June 12th
Posted: 8:37 pm on November 4th
Posted: 9:10 pm on September 27th
As far as the elastic waistband is concerned... I wrap a piece of elastic around my middle to get the length that's comfortable. Then I sew it into a circle and mark the quarters. Position the elastic against the wrong side of the waistline and pin the quarters to the side seams and CF and CB. Make sure the top edge of the elastic is even with the raw edge of the skirt. Then use a serger (or 3-step zig-zag on your sewing machine) to sew the elastic to the edge of the waistline. Stretch the elastic so it just fits the fabric between the pins. Hold the elastic taut as you sew--let the machine feed the edge without holding it back or pulling it through. Then fold the elastic down, (encasing it in fabric). Pin in place and use the 3-step zig-zag to stitch the elastic down. --that's it. Let me know if you need more detail!
Posted: 7:24 pm on February 1st
Posted: 2:36 pm on February 1st
Posted: 2:28 am on February 1st
Posted: 9:52 am on January 11th
This is Perfect!!
Thank you!
Posted: 10:53 am on January 10th
Posted: 4:39 pm on January 6th
Posted: 8:28 am on January 6th
Posted: 9:21 pm on January 1st
Posted: 3:19 am on January 1st
Posted: 12:27 pm on December 31st