How to Transform a Tired Tote with Patchwork
comments (5) January 28th, 2009Next, decide on how you want to place your strips on the part of the bag that is to be covered. I like to cut several scraps to the same width (8 inches in this case, which will cover 7-1/2 inches of the bag when finished) and play with the lengths. I used five pieces to cover 13 inches in length, so, with a 1/4-inch seam allowance for each strip and a 1/2-inch seam allowance for the top and bottom of the patchwork strip, the total length of my scraps (unsewn) was 16 inches.
![]() |
Arrange your strips in a pleasing pattern along the part of the bag you want to cover. |
![]() |
Using a 1/4-inch seam allowance, sew the strips of fabric together, matching the 8-inch lengths. Trim the edges of your patchwork strip if you have any uneven areas. (Since I'm only using a few strips and they all go in the same direction, I pressed the seams all at once—see the next step.)
|
![]() |
Press the back of the patchwork strip so that all of the seams face the same direction. Then, press the sides of the patchwork rectangle under by about 1/2 inch on each side. |
![]() |
With the wrong side of the fabric facing the right side of the bag, pin the patchwork rectangle to the bag. Remember, you can place the rectangle however you want—I placed mine vertically.
|
Carefully sew around the outer edge of the rectangle. It might be kind of tricky to maneuver around the bag, so go slowly and remember that you can stop and start again if you need to. You may also want to topstitch across each of the widthwise seams.
![]() |
Carry your "new" green tote everywhere! No more plastic bags! |
After you make this project, show off your work to other members!
Post your project in the gallery





















Comments (5)
Posted: 8:50 pm on April 18th
Posted: 8:47 pm on April 18th
Posted: 2:15 pm on February 1st
Posted: 4:48 pm on January 29th
Posted: 2:12 pm on January 28th