| Create an Account

Pumpkin Lights from a Canning Jar

comments (0) October 10th, 2010

Pin It

CayleMandy, member

no recommendations

Photo: by Marilyn 2010

Add Comment
Print

First of all I made one with a big mayo jar & I just didn't like it.... I wanted to make it smaller so I looked around & saw my small canning jars... Perfecto!!!

I bought some orange tissue paper & cut them into about 2" strips...long enough so the bottom of the jar can be covered...Cut on the folds of the tissue paper. I used a light decoupage glue(Anitas) & started in small areas to apply it......Using just one layer of the tissue paper, place the tissue strips straight up & down; use your sponge brush to apply gently as the tissue is very fragile at this point.....& it will tear off if you use your fingers.... Pat the tissue down gently too with the brush......

Here is the method I used to make the appearance of creases that pumpkins have; overlap the tissue for the width of the groove you want...... The double tissue covering these sections are darker & simulate the creases a pumpkin has...

You can paint a Halloween face on but I googled cute pumpkin face & printed off the face....I cut the eyes & mouth out from the picture & decoupaged them on... I used the back of the canning jar for the face...

I placed a battery tea light inside so it would glow in the dark.... when turned on...I glued my canning jar lid & cap together & punched a hole in the lid big enough so the tea light flame only could fit through.... I glued the tea light to the cap as well..... This little tealight flame gives the appearance of the stem of the pumpkin & it lights up which gives it extra charm...

Happy Halloween~Marilyn

posted in: houseware, seasonal, halloween, tea lights, canning jar

Add Comment Print