Paper And Wire Wrapped Bead Tutorial

comments (1) February 26th, 2012     

Pin It

MixedKreations MixedKreations, member
Love it! no recommendations
Paper and wire wrapped beads
Cut your wire 2 1/2
Make a simple link.
Simple link & aged paper
Start wrapping
Seal with an adhesive of your choice
Add the wire
wrapping bead
Finished bead
Paper and wire wrapped beads

Paper and wire wrapped beads

Photo: Linda Keesee

Tools you will need:


Round nose pliers, flush cutters, chain nose pliers, ruler, copper wire 18 gauge and 20 gauge, paint brush, some kind of adhesive sealant and protector for decoupage (such as Mod Podge or Liquitex), and an old book with aged pages.

Optional: Liver of sulfur, steel wool

1. First tear out a few aged pages from an old book. Take your paint brush and adhesive/sealant of your choice. Coat both sides of you pages, twice, let dry between coats.

2. Cut 2 ½ inch pieces from your 18 gauge copper wire for however many beads that you want to make.

 

3. With the 2 ½” wires you just cut make simple straight loop links. When you get all your links made, and you would like them to be oxidized. Then now is the time to apply your liver of sulfur. Go ahead and cut 3 – 4 pieces of your 20 gauge copper wire approximately 1 ½ to 2 feet long (you can wrap 3 or 4 beads with 2 ft. pieces. Apply the liver of sulfur to these pieces as well. Use steel wool to clean and polish. Your links can go in a tumbler if you have one.

4. Cut your aged paper into strips, long ways. Cut them just a little smaller than the area between the loops on your links, approximately ¾”. So that you will have plenty of room to make a wrap on each side of the loop, between the link loop and the paper.

5. Start rolling one end of the aged paper strip (just enough to get a little curl in the end to make it easier to get started rolling). Unroll, and now place the link at the end of the paper in the little curl and start rolling. Roll as much as you want, depending on the size of bead that you want. Be sure to keep the paper straight as you roll. When you get to where you have about an inch left to roll, apply some of your adhesive/protector to the underside and finish rolling. Wipe off any excess, hold for a little bit till it starts to stick, then set your first wire wrapped paper bead to the side to dry, and repeat step #5 till you finish rolling the rest. Let dry overnight.

6. Now take your long pieces of wire and make two wraps in between the link loop and edge of the paper, now continue up onto the paper for 4 or 5 wraps then back down to the area in between the paper and loop, make to wraps. Cut the ends of the wire and press down the ends. So you will have a neat wrap. Continue step #6 till you have all the wire wrapped paper beads done.

 

 

posted in: jewelry making, wired wrapping, wrapping wire jewelry, tutorial on wire wrapping, wire wrapped beads, copper wire beads, paper and copper beads, how to make wire wrapped beads

Comments (1)

1kathyr writes: This is SO cool and I actually have all the materials on hand! Thank you for this-I can't wait to make some of these beads!
Posted: 1:10 am on February 24th
You must be logged in to post comments. Click here to login.