How to Make Wearable Wings

comments (1) October 26th, 2008     

Pin It

FriendyWendy Wendy Sloneker, contributor
Love it! 1 user recommends
Ta-da! Oh, yes, you can create these, too!
A butterfly frame.
Add elastic but not too tightly! This is for fitting.
Ta-da! Oh, yes, you can create these, too!

Ta-da! Oh, yes, you can create these, too!

Photo: Wendy Sloneker

Create Your Wings!
For the butterfly wings, start with the upper corner and curve the wire in a large loop. Wrap the end at the center of the rectangle by wrapping the wire and squeezing the coil tight with pliers. Curve a smaller wing at the bottom and wrap wire at the lower corner. Run a length of wire along the lower width of the rectangle, and wrap the wire around the lower opposite corner before beginning to curve the smaller lower wing. Attach in the middle of the rectangle. Estimate the wire you'll need to finish the larger part of the upper wing, then cut the wire and shape the wing. Wrap the wire around the upper corner of the rectangle and snip any excess. Make sure those ends are squeezed tightly—no scratches or snags, please!

Seal the Deal
Using Mod Podge applied with a foam brush or clear acrylic spray will prevent staining while you cover the wire armature with your decoration of choice. Let it dry.

Elastic attachments.



Attach the elastic cords—don't knot them too tightly! Try on the wings for fit, then secure the knots.

Knot Too Tight
Cut two lengths—about 12 inches each—of elastic cord. Tie one end to an upper corner of the rectangle with a square knot. Tie the other end to the midsection of the rectangle with a square knot. Repeat on the other side. Don't tie them too tightly because now it's time to try it on! Adjust the knot or call it good and dab the knots with clear nail polish to secure.

Coverage!
I had some time and some good sunshine to try out plaster cloth and paint. This option is a bit heavier than the others but just as fun! For the plaster cloth, read the manufacturer's directions, follow along, paint your design—and don't forget the glitter, baby!

Draping Plaster Cloth.



Plaster cloth comes in sheets. If you must work in sections, I recommend you complete one section before moving on to the next. I used approximately three small rolls for this set o' wings.

 

Plain Plaster Wings



Otto is "helping." He's really just a camera hog. Good thing the plaster's dry!

Other Ideas to Cover the Wings
• Tulle netting: Use four pieces to cover the wings, and bunch the ends to cover the rectangle structure. Secure the bunch with rubber bands or needle and thread.

• Ribbons: Really thick ones! Wrap and/or weave the ribbons in any fashion you choose. Mylar strips could be very sparkly and fun here!

• Feather boa: Follow along the wing designs with yards of feather boa, and if you're handy with a glue gun, use it. I tend to get burned, so will stick to tacking it into place with needle and thread.

• Old nylon stockings: Two pairs, black or pink? This would be ideal for the long and flat shape of dragonfly wings. Cut the legs off of the stockings, slip the wing into the stocking, and secure to the rectangle structure.

You can cover the rectangle with additional tulle netting or anything else that would camouflage or cover the wire.

Did you make this?
After you make this project, show off your work to other members!
Post your project in the gallery
 
posted in: costume

Comments (1)

sigridsoto writes: Very pretty I will try this one to
Posted: 5:30 am on January 7th
You must be logged in to post comments. Click here to login.